Sök:

Sökresultat:

141 Uppsatser om Camera projection - Sida 1 av 10

Matte painting och camera projection inom VFX-produktion

Matte painting och Camera projection är ett relativt snabbt och kostnadseffektivt sätt att skapa miljöer som inte existerar. I denna rapport redovisar jag om matte paintings användning inom VFX-produktion och går igenom hur man uppnår ett effektivt arbetsflöde med godtagbara slutprodukter. Jag redovisar skillnaden mellan 2D, 2.5D och 3D-genererade miljöer och vad som bör användas vid olika situationer. Jag rapporterar även om områdets generella utveckling samt i vilken riktning dess utveckling ser ut att gå..

Utvärdering av Di35M-PrLO-projektion av armbågsleden för utlinjering av mediala processus coronoideus hos hund :

The aim of this study is to evaluate an alternative projection of the Medial Coronoid Process (MCP) of the canine elbow joint. The projection (Di35M-PrLO) was, to my knowledge, first mentioned in an article by Haudiquet et al in 2002. In that article the projection was tested in vitro, and a good sensitivity was showed for the Medial Coronoid Process. The projection might be helpful in cases of suspected Fragmented Coronoid Process (FCP) . This study is divided into three parts. The first part is an in-vivo test of the projection, including technique and subjective evaluation of the outlining of the MCP.

Digital compositing i 3D-miljö

I dagens visuella effekter är digital compositing en av de viktigaste processerna. Från att uteslutande ha utförts i 2D har digital compositing dock kommit att innebära en alltmer tredimensionell process. Det här arbetet reder ut begreppet 3D-compositing och sammanställer vilka 3D-compositingtekniker som är vanligt förekommande. Ett urval av dessa tekniker tillämpas sedan i en egen effektsekvens. Slutsatsen blir att det är kombinationen av 3D-funkionalitet och 2D-compositing i samma program som är styrkan med digital compositing i 3D-miljö..

Hur ett företags processer påverkas utav införandet av en säsongsprodukt : en jämförande studie mellan ett storskaligt och ett småskaligt företag veksamma inom livsmedelsindustrin

Matte painting och Camera projection är ett relativt snabbt och kostnadseffektivt sätt att skapa miljöer som inte existerar. I denna rapport redovisar jag om matte paintings användning inom VFX-produktion och går igenom hur man uppnår ett effektivt arbetsflöde med godtagbara slutprodukter. Jag redovisar skillnaden mellan 2D, 2.5D och 3D-genererade miljöer och vad som bör användas vid olika situationer. Jag rapporterar även om områdets generella utveckling samt i vilken riktning dess utveckling ser ut att gå..

Realtidsstyrning av IP-kamera

The final thesis named Tracking in Sensor Networks was created by the company Instrument control Sweden. The thesis work is to create a plug-in to an already developed software pro- gram, SkyView. Via the software program one should be able to control an IP-camera from AXIS, model 215 PTZ, with the appropriate protocol over a network.  An Application Programming Interface, API, was used to easily control the camera through SkyView. The interface is called VAPIX and is used to all cameras from AXIS.

Shape from Silhouette Scanner

The availability of digital models of real 3D objects is becoming more and more important in many different applications (e-commerce, virtual visits etc). Very often the objects to be represented cannot be modeled by means of the classical 3D modeling tools because of the geometrical complexity or color texture. In these cases, devices for the automatic acquisition of the shape and the color of the objects (3D scanners or range scanners) have to be used. The scanner presented in this work, a Shape from silhouette scanner, is very cheap (it is based on the use of a simple digital camera and a turntable) and easy to use. While maintaining the camera on a tripod and the object on the turntable, the user acquires images with different rotation angles of the table.

The Surveillance Camera Players : Ett konstnärligt motstånd mot övervakningssamhället

The purpose with this essay is to examine how arts and politics integrate to raise urgent messages and call upon social changes. Performance art as an artistic manifestation against the surveillance society has been studied to clarify this integration and through an empirical examination of the anarchistic performance group The Surveillance Camera Players. This group formed in New York City 1996 as a manifestation against the increased use of surveillance cameras in public places in Manhattan. Through performance in front of these cameras, The Surveillance Camera Players are able to express their protest against the surveillance society which, occurring to them, violates citizens constitutionally right to privacy. The development and signification of the surveillance society are examined through theoretical perspective by foremost Michel Foucault, but also by contemporary scientist in that field.

A comparison of commercial scent lures in attracting Raccoon dogs (Nyctereutes procyonoides)

The invasive species raccoon dog (Nyctereutes procyonoides) is currently under establishment Sweden and it is vital to discover invading individuals to prevent colonization. The use of wildlife cameras to discover dispersing raccoon dogs have been implemented in the north-European raccoon dog management program. In this study, I test the ability of four commercially available scent lures to attract raccoon dogs to camera stations. The study was conducted in the Åland Islands where raccoon dogs are abundant and the results could improve the effectiveness of the camera stations used in the program. I used 12 sites with five camera stations in each and tested the four lures and one control with no lure in each site.

Trådlös kamerastyrning

As an amateur it can be difficult filming from several angles at the same time as this requires several cameras. It´s also hard to film at occasions when it´s not appropriate to manoeuvre the camera manually. Systems for solving these problems already exist, but it´s either more expensive, professionalsystems or cheaper systems with limited functionality.The purpose of this project is to develop a cost efficient solution to the problem above that offers a better functionality then existing commercial systems. The biggest difference from existing products is the wireless video feedback from the camera to the remote unit.The result of the project is a system consisting of two units, a manoeuvre unit with a cradle for the video camera and a remote unit from which the operator can control pan and tilt of the video camera.Communication between the two units is wireless.On the remote unit there is a joystick and a display mounted. In addition to this, there is also an IR receiver that is capable of reading the signal from the cameras own remote and sending it to the manoeuvre unit.The manoeuvre unit is equipped with one motor to control the tilt function and one motor to control the pan.

Kameraövervakning : En juridisk analys

Camera surveillance can provide good protection against certain types of crime, but it can also invade our privacy. The County Administrative Board monitors compliance with the rules by visiting those places to which the general public has access. They have to issue permits before general camera surveillance to those places which the general public has access. In certain cases, in stores for example, general camera surveillance is permitted only if the Country Administrative Board is notified in advance. The Data Inspection Board is a public authority and responsible for the camera surveillance for those places to which the public not has access.

Designkoncept av ?toycam? : Framtagning av koncept för analog kamera

Analogue photography is something that many thought died out in the beginning of the 21?st century as a result of the digital revolution. But that?s not the case. As the digital revolution swept over the world a movement of analogue cameras, and so called toycams grew bigger.

Datorsystem för kvalitetskontroll och temperaturövervakning med värmekamerateknik

The work was carried out on Termisk Systemteknisk?s office in Linköping. The aim was to create a computer system with infrared camera technology for quality control and temperature monitoring of manufacturing processes in industry. The system should be configurable such that it can be used on several different issues, including those where the real-time analysis of camera images is required.The developed system is based on an existing framework, Panola, to deal with measurement results and images in a database. The framework is built for the system continually check for new data , and the task was to create a foundation upon which to build systems that use the framework, but fully or partially utilize direct calls .

En övervikt av kvinnor : En kvantitativ studie av bilder och skribenter på Aftonbladets viktsajt ur ett genusperspektiv

We have investigated the visual representation of men and women in Aftonbladet?s weight site. We have made a calculation of how many of the women and the men who were portrayed smiling/ not smiling, active/passive, looking into the camera/looking away from the camera and from which camera angle the picture is taken. We also kept statistic on the gender representation of the authors of the articles.Our investigation shows that Aftonbladet?s weight site has a distinct overrepresentation of women on their pictures, but also in terms of the authors of the articles.

Fjärrstyrning av videokamera

On some occasions it may be inappropriate with a cameraman behind the camera. In somecases there is no cameraman available or it is a smaller event, like a family celebration, to befilmed. It can also be difficult for a cameraman to shoot from certain angles. One solution forthis kind of situations can be to remotely control the camera movements. There are thosekinds of solutions on the market today but they either address professional filmmakers or thefunctionality is limited, for example by the absence of wireless remote control.This project aims to develop a solution to the problem with absence of wireless remote controland also a solution with more flexibility and less complexity than today?s solutions.

Narrativ i visuell media

Denna undersökning omfattar kamerans inverkan på narrativet i visuella medium. Syftet är att få en insikt i hur kunskap om kameratekniker och ?vinklar påverkar hur åskådaren uppfattar vad regissören vill förmedla, och undvika att fokus sätts på element i filmscener som riskerar att förvirra åskådaren. För att undersöka detta problemområde har litteratur om filmhistoria och kamerateknik använts för att sammanfatta kunskap om hur kameran skall användas, för att förmedla relevant information och bygga upp den effekt som regissören strävar efter. Informationen utifrån detta har därefter tjänat som utgångspunkt för att skapa en kort animerad film med rymdtema där kameran eftersträvar att leverera en konkret visuell upplevelse där vinklar används för att understryka vad varje scen vill förmedla.

1 Nästa sida ->